Replacing the housing or camshaft
To replace the camshaft housing or the camshaft itself, perform the following steps.
■ Remove the cylinder head.
■ Place the removed camshaft housing on two wooden blocks.
■ Unscrew the housing cover.
■ Remove the bolt securing the sprocket to the camshaft. In doing so, the camshaft must be immobilized with a spanner, which is inserted between the cam of the intake valve 3. cylinder and bearing.
■ Remove the bolts securing the distributor drive housing and the fuel pump, remove the cover.
■ Pull the worm gear of the distributor drive off the camshaft.
■ Unscrew the rear housing cover.
■ Unscrew the camshaft retaining plate.
■ Carefully slide the camshaft back out of the housing
■ Place new camshaft housing on wooden blocks.
■ Carefully guide the shaft with the retaining plate into the housing.
■ Attach the retaining plate.
■ Screw on the rear housing cover with the gasket stuck with grease.
■ Screw the housing under the ignition distributor. The oil hole facing the worm wheel must be unobstructed.
■ Push the worm wheel onto the camshaft journal.
■ Install the ignition distributor, as described in the related chapter.
■ Install the fuel pump.
■ Knock the sealing ring into the ignition distributor drive housing
■ Slide the pinion onto the camshaft pin and fasten with the bolt. Tighten the bolt to the torque 45 Nm. immobilizing the shaft with a flat spanner as during disassembly.
■ Place the camshaft housing on the cylinder head, in which the locating sleeves must be placed.