Repair of tubeless tires up to 6mm. Tubeless tires pump air directly into the tire and if the correct pressure is maintained, …
Category Archives: Malfunctions
Cold car inner tube repair
Cold car inner tube repair. Inner tubes can be repaired cold or hot. Cold repair involves: …
Repair of a damaged car inner tube
Repair of a damaged car inner tube. To remove the inner tube from the tire, belongs: a) Deflate completely by unscrewing the inner tube valve insert, and then pressing the tire right off …
Deficiencies in the independent suspension
Typical ailments and maintenance of the independent suspension. The most common failures are the wear of the rocker arm pins and bushings as a result of hard working conditions (water, short, mud) and locking of the pins …
Riveting of the clutch plate linings
Riveting of the clutch plate linings.
Usually the friction linings are delivered with the rivet holes already drilled. Rivet heads should be countersunk below the friction surface, therefore the holes …
Replace the friction linings of the clutch disc
Replace the friction linings of the clutch disc.
Before replacing the friction linings, the clutch disc must be checked, whether it has twisted. Replace the twisted shield with …
Vibration when engaging the clutch
Vibration when engaging the clutch, the so-called. clutch jerking, may occur in the case of e.g.. jamming of the clutch disc hub on the shaft, damage to the friction linings, damage to the shock absorber springs …
Ford Mondeo MK3 Chassis
The advantage of the Ford Mondeo MK3 is the chassis. The front wheels are independently suspended from McPherson struts with coil springs and angled shock absorbers, lower wishbones with …
EXHAUST – Fiat Uno
EXHAUST – Fiat Uno
The task of the exhaust system is to collect the gases flowing from the manifold, cooling them and draining them through the muffler to the rear of the car. It is important to, to …
Malfunctions in the direct injection engine,
There are certainly many other faults in the environment of modern direct injection engines. There will always be faults, the cause of which will not be immediately …