Setting wheel alignment
The steering gear must be in a position suitable for driving straight ahead. In addition, the clamp bolt on the steering shaft must lie down …
Setting wheel alignment
The steering gear must be in a position suitable for driving straight ahead. In addition, the clamp bolt on the steering shaft must lie down …
Replacing the steering rod
■ Remove the air filter housing
■ Loosen the clamp bolt at the end of the tie rod.
■ Remove both protectors from the spacer, squeezing with a screwdriver …
Setting the steering gear
Setting steering gear to center position, i.e.. corresponding to driving straight ahead, is required after all repair work on the gearbox, as well as after installation …
Flexible coupling replacement
■ Move the steering gear to the center position, i.e.. as for driving straight ahead.
■ Remove the screws from both terminals on the steering shaft …
Pump control
VP44 manages the operation of the pump, as we know, electronic engine control system EDC. The first VP44 and VP30 pumps required two controllers: MSG engine controller and …
Construction and operation of the VP44 pump
The radial distributor injection pump consists of a vane chamber pump with a pressure control valve and an overflow throttle valve. Its job is …