Service and replacement of the fuel filter (engine 1,6 D)
As part of the recommended periodic inspections, remove water from the fuel filter or …
Service and replacement of the fuel filter (engine 1,6 D)
As part of the recommended periodic inspections, remove water from the fuel filter or …
Service and replacement of the fuel pump (engines 1,2 and 1,3)
Motors 1,2 and 1.3 are equipped with mechanical diaphragm type fuel pumps
To clean the mesh …
Replacing the fuel level sensor
The fuel level sensor can be replaced when the fuel tank is installed. The sensor is unscrewed using a special Opel KM ring spanner 332-01. which four …
Radiator replacement
■ Remove the air cleaner intake hose.
■ Detach the bottom rubber hose from the radiator. Collect the leaked liquid in a vessel.
■ Disconnect the upper one from the radiator …
Coolant pump replacement (engines 1,3 and 1,6 D)
■ Disconnect the battery mass cable.
■ Disconnect the bottom rubber hose from the radiator. Collect the leaking vessel …
Coolant pump replacement (engine 1,2)
■ Disconnect the rubber hoses to the coolant pump. Collect the leaking liquid in a container.
■ Loosen the pulley bolts …
Thermostat replacement (engine 1,2)
The thermostat is located on the top of the coolant pump. Disconnect the hose that goes to this socket and collect the leaked liquid. …
COOLING – Opel Kadett
The engine cooling system is of the forced type, with belt driven centrifugal pump (engine 1.2) and toothed belt (engines 1,3 and 1,6 …
Checking the oil pressure
The oil pressure sensor is located in the engine block, on the rear right as seen in the direction of travel
■ From an oil pressure sensor …
Replacement of the reduction valve (engines 1,3 and 1,6 D)
The task of the reduction valve is to stabilize the oil pressure in the lubrication system. The valve is located on the side of the hull, for …