Replacing the camshaft and bearings
The engine must be removed from the vehicle to remove the camshaft. In addition, at least the following must be removed …
Replacing the camshaft and bearings
The engine must be removed from the vehicle to remove the camshaft. In addition, at least the following must be removed …
After removing the timing cover, turn the crankshaft this way, to "rip" the alignment marks on both gears. If there is no such need, to w …
Replacing the timing chain tensioner
The timing chain tensioner is accessed by removing the cover. After unscrewing both mounting bolts, carefully remove the tensioner. paying attention, …
DISTRIBUTION (ENGINE 1,2)
Timing cover replacement
This operation can be performed with the engine left in the vehicle as follows.
■ Loosen the alternator mounting and remove the belt …
Needle roller bearing replacement
Replacing the needle bearing in the crankshaft journal requires the removal of the clutch and the flywheel. A special multi-piece tool Opel-KM-469 is used to build a needle bearing. …
Replacing the crankshaft front seal
The following description applies to motors 1.3 and 1,6 D which have not been removed from the car.
■ Loosen the alternator mounting and remove it …
Replacing the crankshaft rear seal
Replace the rear seal, more particularly, the crankshaft seal ring can be performed without removing the engine from the vehicle. However, the clutch must be removed …
Checking the crankshaft
After dismantling, thoroughly wash all elements in gasoline and blow out with compressed air, including oil channels. To check, whether the crankshaft is not …