Change the oil filter
The oil filter must be replaced regularly, in accordance with the manufacturer's recommendations. It is possible to check, whether the oil filter is clogged …
Change the oil filter
The oil filter must be replaced regularly, in accordance with the manufacturer's recommendations. It is possible to check, whether the oil filter is clogged …
Replace the oil pan gasket (engines 1,3 and 1,6 D)
■ Drain the engine oil.
■ Screw the oil drain plug back in with a new seal (moment …
The engine is lubricated under pressure, produced by a gear pump, which one in the engine 1.2 it is housed in the crankcase and driven by the camshaft, a …
Camshaft replacement
■ Remove the engine head
■ Place the camshaft housing on two wooden blocks and remove the cover.
■ Remove the gear wheel fixing bolt …
Checking and adjusting the timing setting
■ Remove the air filter.
■ Remove the air filter.
■ Remove the camshaft housing cover.
■ Remove the clutch housing cover.
■ …
Replacing the toothed belt
■ Disconnect the battery from the vehicle's electrical system.
■ Remove the air filter.
■ Remove the cover from the clutch housing.
■ Remove the V-belt.
■ …
DISTRIBUTION (ENGINE 1,6 D)
Checking and adjusting the toothed belt tension
■ Loosen the alternator mounting and remove the V-belt.
■ Remove the upper and lower belt covers …
Replacing the housing or camshaft
To replace the camshaft housing or the camshaft itself, perform the following steps.
■ Remove the cylinder head.
■ The shaft housing has been removed …
The toothed belt tension is checked with a special measuring device Opel-KM-510. With a correctly tensioned strip, the instrument indications should be as follows.
Toothed belt | ||
new | used | |
Engine: | ||
– cold |
DISTRIBUTION (ENGINE 1,3) Replacing the toothed belt
Unscrew the metal cover of the toothed belt. Rolling the car with the gear engaged, "match" the setting mark on the crankshaft pulley …